. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN TRANSMISSION CASE AND TRANSMISSION OIL FILTER CARTRIDGE, CLEAN STRAINER WARNING engine is stopped, and may cause burns. Wait for the 4 - 53 EVERY 1000 HOURS Maintenance for every 50 , 100, 250 and 500 hours ser vice should be carried out at the sa The parts and oil are at temperature to go down b When removing the oil fill er cap, turn it slowly to release th e internal Refill capacity: 54 liters Prepare a filter wrench 1. Set a container to ca tch the oil under drain plug (P), then and drain the oil. pouring out suddenly, loosen drain plug remove drain plug (P) To prevent the oil from (P) and remove it gra dually. nstall drain plug (P).
6 ± 9.8 Nm (7.0 ± 1.0 kgm, 50.6 ± 7.2 ) ch the oil under the transmission filter. 2. After draining the oil, i Tightening torque: 68. lbft Tightening torque: 68. 3. Set a container to cat ch the oil under the transmiss ion filter. 4. Remove drain plug (1 ) of the transmission filter, drain the oil, gain. then tighten the plug a 5. Using a filter wrench, t urn filter cartridge (2) to the left to remove it. 6. Clean the filter holder, new filter cartridge wit coat the seal surface and thr h clean oil, then install it. ead of the 7. When the seal surface comes into contact with the fi lter holder, tighten a further 2/5 tu rns with the filter wrench. 8.
Remove 4 bolts (3), m ove tube (4), then remove str ainer (5) . 9. Remove any dirt stuc k to strainer (5), then wash it in clean 10. diesel fuel or flushing oil. If strainer (5) is damaged , replace it with a new part. Install strainer (5) in th e case. Replace the O-ring of tube (4) with a new part, then install tube (4).