. ATTACHMENTS, OPTIONS HANDLING LOAD METER ATTACHMENTS, OPTIONS HANDLING LOAD METER 4. Press the ( ‘ ) of monitor panel selector switch 1. "EMPTY BUCKET" is displayed on the bottom line. back fully, then lower the lift arm to set to the travel posture. 6 - 17 5. Press the () of monitor p anel selector switch 1. The d isplay changes to "STEP 1" on BACK" and "AT CARRY the top line, and "FULLY POSI" are displayed in turn ROLL for 3 seconds each on the botto Follow the instructions on 7. When the lift arm is lowere d, the display changes to "STEP 2" 8. and "RAISE TO TOP". n for setting the calibration when e screen and raise the lift arm fully. This completes preparatio empty.
Follow the instructions on th When raising the lift arm, actual operation as possibl carry out the operation as close to e. 9. correctly, the buzzer gives display returns to the norm al service meter and time displa 10. If the setting of the empty ca libration is not completed correctly, the buzzer gives a long s ound, and the display returns to "CALIBRATION" on the top line and "EMPTY BUCKET" on t he bottom line. Repeat the procedure agai