COLD WEATHER OPERATION 3.5.3 AFTER DAILY WORK COMPLETION Performing idle-running of the tracks is dangerous, so stay well away from the tracks. To prevent mud, water, or the undercarriage from freezing and making it impossible for the machine to move on the following morning, always observe the following precautions. Remove all the mud and water from the machine body. In particular, wipe the hydraulic cylinder rod clean to pre- vent damage to the seal caused by mud or dirt on the rod surface getting inside the seal together with drops of water. Park the machine on hard, dry ground. If this is impossible, park the machine on wooden boards.
The boards help protect the tracks from being frozen in soil so the machine can move next morning. Open the drain valve and drain any water collected in the fuel system to prevent it from freezing. After operation in water or mud, remove water from undercarriage as described below to extend undercarriage service life. 1. Swing 90° with engine at low idling and bring the work equipment to the side of the track. 2. Jack up the machine until the track is raised slightly from the ground. Rotate the track under no load. Repeat this procedure on both the left and right sides. 3.5.4 AFTER COLD WEATHER SEASON When season changes and the weather becomes warmer, do as follows.
Replace the fuel and oil for all parts with oil of the viscosity specified. For details, see "4.2 LUBRICANTS, COOLANT AND FILTERS". 144 WARNING