D 2008/2009 Drive system W 02-04-01 z Dismantle assembly tool. z Remove assembly tool. z Check that the lubricating oil bore is in line. If the lubricating oil bore is not in line, the bearing bush must be removed and re- installed. z Check installation depth of the bearing bush with depth measuring appliance. ca. 3 mm 6 © 41064-1 Installing the crankshaft z Lightly oil bearing bush (1) with engine oil. 1 z Push crankshaft into crankcase. Align screw thread (2) and through hole (3). z Insert thrust washers (4) at the rear with grease. 4 Lubricating oil grooves face the crankshaft. 3 2 © 41036-1 z Push in the crankshaft in the direction of the arrow to the stop. z Tighten locating screws (1).
z Install oil suction pipe. W 08-04-06 1 © 41037-1 © 02/2006 6001-001 6/10