OM7001 Optional Equipment - Section 7 Cab Radio Page 7-5 BAD TAPE DETECT CASSETTE PLAYER CLEANING If the receiver detects a bad cassette, “BAD TAPE” will appear on the display, and the tape will be ejected. If this occurs, the cassette should be removed from the player and should not be re- inserted. After 35 hours of cassette play, the display will read "TP CLEAN" for 5 seconds. This indicates that it is time to clean the cassette player. 1. Turn the key switch to "ON", and turn the receiver "OFF". If it is desired to use a cleaning tape or a CD adapter in the cassette player, the bad tape detector must be turned “OFF”. Perform the following steps in order to disable this mode: 2.
Disable "BAD TAPE DETECT" mode. 3. Turn the receiver "ON". 4. Insert a wet-type, non-abrasive, scrubbing cas- sette cleaner. Follow the instructions provided with the cleaner. 1. Turn the receiver “OFF” and turn the key switch to “OFF”. 5. Reset the clean tape timer. With the receiver "ON", press and hold the eject button for 5 sec- onds. "TP CLEAN" will appear on the display and the tape icon will flash after 3 seconds has elapsed. After 5 seconds “CLN RST” will appear on the display. When this occurs, the clean tape timer will be reset to zero hours. If the button was released before “CLN RST” was displayed, the timer will not be reset. 2. Press and hold button (3) for 5 seconds.
“BAD TAPE DETECT OFF” will appear on the display. When this is displayed, the detector has been disabled. Repeat this procedure to reactivate the bad tape detector. “BAD TAPE DETECT ON” will appear on the display after the detector has been activated.