OM2034 General Safety ANCE ersonnel can service and repair the machine. Extra precaution should be used when nd using a sledge-hammer. that have been removed from the machine in a safe place so . If they fall on you or others, serious injury could result. ACHINE ovable work equipment to the ground or to their lowest orming service or repairs under the machine. es of the machine securely. he machine if the machine is poorly supported. CLEAN se, or scattered tools or broken pieces are dangerous cause you to slip or trip. Always keep your machine clean e electrical system, there is danger that the machine may ove unexpectedly.
Do not use water or steam to clean the s, or the inside of the operator's compartment. ul washing the electrical control cabinet. Do not allow any control cabinet around the doors or vents. Do not allow the cooling air inlet duct above the electrical control cabinet. If water enters the control vent or the cooling air system) major damage to the electrical components is possible. nto the rear wheel electric motor covers. Damage to the wheel motor armature can occur. into the retard grids. Excess water in the retard grids can cause a ground fault, which will WHEN ADDING FUEL OR OIL may cause slipping. Always clean up spills immediately. cap of the fuel and oil fillers securely.
ashing any parts. d oil in a well-ventilated place. nd the doors or vents. Do not allow t duct above the electrical control cabin ir system) major damage to the electrical lectric motor covers. Damage to the whe s. Excess water in the retard grids can c EL OR OIL Always clean up spills immediately. il fillers securely. ted place. et. If water enters the control components is possible. el motor armature can occur. ause a ground fault, which will