12. OPERATION 12.1.4 ADJUST STEERING, DIRECTIONAL, SPEED LEVER (WRIST CONTROL TYPE SINGLE LEVER :JOYSTICK) The steering, directional, and speed lever (wrist control type single lever :joystick) can be adjusted by 100 mm in 5 stages to the front or rear. Adjust to the most suitable position to match the adjustment of the operator’s seat. 1. Pull up lock levers 1 and 2 to release the locks. 2. Hold handle 3 and move case 4 to the front or rear. The whole case including the steering, directional, and speed lever (wrist control type single lever :joystick) will move. 3.
When moving the case, set it in the desired position where it clicks into the notch, then push lock levers 1 and 2 to apply the lock. ADJUST ARMREST The height of the armrest on the left and right sides of the operator’s seat can be adjusted to 3 positions. After adjusting the operator’s seat, adjust the armrest to a suitable height. 1. Loosen knob 1 on the left and right sides of the operator’s seat. 2. Move the armrest on the left and right sides of the operator’s seat to the front, then align the position of the 3 holes (high, middle, low). 3. Tighten knob 1 securely. 2-45