. OPERATION MACHINE OPERATIONS AND CONTROLS has from Step 4. 3 - 69 Check for Water and Sediment in Water Separator, Drain Water 1. Open th e cover at the rear right 2. Inspect the water separator, an the marked line. g has risen to the marke risen to If the rin 4. Prepare a container to catch th e drained fuel and set i t under the wate r separator. m of the fuel tank. e top of the water separator. 5. Close fu el valve (6) at the botto 6. Remove air bleed plug (5) at th e top of the water separator. 7. Loosen drain valve (1) at the b ottom of the water separator, 8. 9. and drai Loosen Remove n the water and sedime ring nut (2), then remov element (4) from the s nt into the container.
e filter case (3). eparator base. e (3) in clean diesel oil. it if it is damaged. erform Steps 5 and 9 in the ): .7 ± 2.2 lbft) 10. Wash el ement (4) and filter cas 11. Check e lement (4) and replace 12. When i nstalling element (4), p order. opposite Tighteni 40 ± 3 N ng torque of ring nut (2 ·m (4.1 ± 0.3 kgf·m, 29 13. Loosen air bleed plug (5) then F ill filter case (3) with fuel. When the fuel comes out from air blee d plug (5), tighten air bleed plug (5).