. OPERATION MACHINE OPERATIONS AND CONTROLS GENERAL OPERATION INFORMATION (1). The travel speed is displayed as Lo, Mi, or Hi on the monitor display. 3 - 105 Traveling Traveling over boulders , tree stumps, or other obstacles wi ll cause a big shock to the chass is (and in particular to the tracks), and this will cause damage to the machine. For this reason , always remove any obstacles or travel around them, or take othe traveling over such obs tacles as far as possible. If there is no way to av travel speed, keep the w ork equipment close to the ground, and try to travel so that the cen ter of the track passes ov er the ob stacle.
High Speed Travel On uneven roadbeds su ch as rock beds or uneven roads wi th large rocks, travel at Lo spee idler in the forward direc To switch the travel d. When traveling at high speed, set the tion. speed, press travel speed selector switch Permissible Water Dept h NOTICE When driving the machine out of water, if the angle of the machine exceeds 15°, the rear of the upper structure will go under water, and wate r will be thrown up by the radiator f an. This may cause the fan to break. ater. Be extremely careful when driving the machine out of w Do not drive the machin e in water deeper than the center o f carrier roller (1).
Supply grease to the pa rts which have been under water fo r a long time until the used grea se is projected out of the b earings ( around the bucket pin, in partic ular).