RENR5042-02 23 Troubleshooting Section System Configuration Parameters Table 9 (continued) System Configuration Parameters Parameter Available Range or Options Default Required Password ECM Identification Parameters “Equipment ID” 17 alphanumeric characters “NOT PROGRAMMED” None “Engine Serial Number” 0XX00000 or XXX00000 0XX00000 None “ECM Serial Number” “Read Only” (1) “Software Gp Part Number” Software Dependent Read Only (1) “Software Gp Release Date” Software Dependent Read Only (1) Selected Engine Rating “Rating Number” Software Dependent Customer “Rated Power” Software Dependent Read Only (1) “Rated Peak Torque” Software Dependent Read Only (1) “Top Engine Speed Range” Software Dependent Read Only (1) “Test Spec” Software Dependent Read Only (1) “Top Engine Limit” Software Dependent Customer “Engine Accel.
Rate” 50 to 1000 50 None “Low Idle Speed” 600 to 1400 700 None “PTO Mode” “Ramp Up/Ramp Down” “Set/Resume” “Ramp Up/Ramp Down” None “High Idle Speed” 1800 to 2310 2310 Customer “Intermediate Engine Speed” Programmed “Low Idle” to “TEL” 1100 None “Engine Power Trim” This parameter cannot be changed.
“Maximum Engine Torque Limit” Software Dependent None “Customer Password #1” 8 alphanumeric characters Blank Customer “Customer Password #2” 8 alphanumeric characters Blank Customer “FLS” (Full Load Setting) - 128 to 127 0 Factory “FTS” (Full Torque Setting) -128 to 127 0 Factory “Ether Control” “No Ether” “Continuous Flow” “No Ether” None “Air Shutoff” “Enabled” “Disabled” “Disabled” None “Maintenance Indicator Mode” “OFF” “Auto Fuel” “Auto Hour” “Man Fuel” “Man Hour” “OFF” None “PM1 Interval” 100 to 750 Hours or 3785 to 28390 L (1000 to 7500 US gal) 250 Hours or 9463 L (2500 US gal) None “Throttle Position Sensor” “Installed” “Not Installed” “Not Installed” None “Coolant Level On” “Installed” “Not Installed” “Not Installed” None