56 RENR5042-02 Troubleshooting Section (Table 14, contd) (1) Suspect Parameter Number (2) Caterpillar Electronic Technician (ET) will display the number 1, 2, or 3 after the event code in order to designate a warning, a derate, or a shutdown. i02257686 CID 0001 FMI 05 Injector Cylinder 1 open circuit Troubleshooting: Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” SMCS Code: 1290-038 Results: Conditions Which Generate This Code: OK STOP. The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open circuit in the circuit for the injector. i02257712 CID 0001 FMI 06 Injector Cylinder 1 short System Response: SMCS Code:
1290-038 The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Conditions Which Generate This Code: Possible Performance Effect: The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects a short circuit in the circuit for the injector. Engine misfires Low power System Response: The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged.
Cross Reference for Diagnostic Codes Flash Code SPN(1)/FMI Code Diagnostic Code or Event Code Description of Code 72 652-05 002-05 Injector Cylinder 2 open circuit 652-06 002-06 Injector Cylinder 2 short 652-11 002-11 Injector Cylinder #2 fault 73 653-05 003-05 Injector Cylinder 3 open circuit 653-06 003-06 Injector Cylinder 3 short 653-11 003-11 Injector Cylinder #3 fault 74 654-05 004-05 Injector Cylinder 4 open circuit 654-06 004-06 Injector Cylinder 4 short 654-11 004-11 Injector Cylinder #4 fault 75 655-05 005-05 Injector Cylinder 5 open circuit 655-06 005-06 Injector Cylinder 5 short 655-11 005-11 Injector Cylinder #5 fault 76 656-05 006-05 Injector Cylinder 6 open circuit 656-06 006-06 Injector Cylinder 6 short 656-11 006-11 Injector Cylinder #6 fault