60 RENR5042-02 Troubleshooting Section i02214587 CID 0004 FMI 11 Injector Cylinder #4 fault Possible Performance Effect: Engine misfires Low power SMCS Code: 1290-038 Troubleshooting: Conditions Which Generate This Code: Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open circuit or a short circuit in the circuit for the injector. Results: If the cause of the diagnostic code is a problem in the common wire, two cylinders will be affected because of the shared common wire for the injectors. OK STOP. System Response:
i02257807 CID 0005 FMI 06 Injector Cylinder 5 short The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. SMCS Code: 1290-038 The injector may not operate while the condition exists. Conditions Which Generate This Code: Possible Performance Effect: The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects a short circuit in the circuit for the injector. Engine misfires System Response: Low power The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged. Perform the following diagnostic procedure:
“Injector Solenoid Circuit - Test” Results: Possible Performance Effect: OK STOP. Engine misfires Low power i02257799 CID 0005 FMI 05 Injector Cylinder 5 open circuit Troubleshooting: Perform the following diagnostic procedure: “Injector Solenoid Circuit - Test” SMCS Code: 1290-038 Results: Conditions Which Generate This Code: OK STOP. The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open circuit in the circuit for the injector. System Response: The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged.