UNDERCARRIAGE / Center Joint When replacing the body or spindle with new one, the following procedures are required. In case of Body (12) 1. Clean body (12) and bushing (5). 2. Install bushing (5) into body (12) by using a press. Grease or molybdenum disulfide shall be applied to the fitting surface. Pressing force: 0.5 to 1.5 t (1100 to 3300 lb) Pressing tool: ST 2558 In case of Spindle (2) 1. Clean spindle (2). 2. Tap plug (1) into spindle (2) by using special tool (ST 2559). 3. Tap the balls of plug (1) so that the top of each ball is 0.4 mm (0.016 in) or more than the respective sleeve edge as illustrated in detail D.
1 0.4 mm or More 2 Detail D W135-03-03-001 W136-03-03-031 W105-03-03-029 Ball W157-03-03-004 W3-3-8 ST 255 12 5 e Sleeve ST 2559