UNDERCARRIAGE / Upper And Lower Roller Assemble Lower Roller 1. Install bushings (7) (2 used) to roller (8). Do not dent the flange surface of bushing (7). Apply grease to O-ring (3). Install O-ring (3) to axle (2). 2. Align the matching marks made when disassembling. Install collar (4) at one side to axle (2). Secure with pin (3). Do not damage O-ring (3) at this time. IMPORTANT: For handling floating seal (5), refer to the section “Precautions for Handling Floating Seal” on page W1-1-4. 4. Install floating seal (1) to roller (8) and collar (4). 5 2 3 W16J-03-06-001 3. Apply LOCTITE #503 to plug (6). Install plug (6) to collar (4) at one side. 4 W157-03-06-008 5.
Insert axle (2) into roller (8). Install O-ring (3) to axle (2). Install other collar (4) in the same procedures. Secure collar with pin (5). 6. Add engine oil through the plug (6) hole on collar (4). Engine oil: API CF class, SAE15W-40 Oil Amount: 0.42 L (0.11 US gal.) IMPORTANT: Apply LOCTITE # 503 or equivalent to plug (1). (Sealant is applied to new plug (6).) 7. Install plug (6) to collar (4). : 6 mm : 29.5 N m (3.0 kgf m, 22 lbf ft) : 29.5 N m (3.0 kgf m, 22 lbf ft) : 6 mm W105-03-06-024 W3-6-11 8 1 1 4 8 5 4 8