FRONT ATTACHMENT / Cylinder REMOVE AND INSTALL CYLINDER Remove Bucket Cylinder 1. Insert wooden block (3) under the arm (2) top and between arm (2) and bucket cylinder (1). CAUTION: Before removing pin (7), fasten the link by using a wire in order not to fall off. CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. 2. Remove nuts (6) (2 used) and bolt (4). Remove pin (7). Remove thrust plate (5). W178-02-11-287 : 32 mm 3. Operate the bucket lever and retract bucket cylinder (1).
In order not to extend rod (8), pass wire (9) through the cylinder rod hole and secure rod (8) to the bucket cylinder (1) tube. 4. Stop the engine. Push the air bleed valve and release any remaining pressure in the hydraulic oil tank. Remove the cap. Release the bucket circuit pressure. Refer to the Hydraulic Circuit Pressure Release Procedure section on W4-2-1. W158-04-02-006 W102-04-02-005 W4-2-2 1 3 3 2 4 5 6 7 1 8 9