Components EMU26400 Top cowling release lever The top cowling can be removed by operat- ing the cowling release lever. Pulling the front lever unlocks the top cowling for remov- al. A B ZMU01863 Bolt tightening torque: 42.0 Nm (4.2 kgf-m, 31 ft-lb) EMU26341 Tilt support lever for power trim and tilt model To keep the outboard motor in the tilted up position, lock the tilt support lever to the clamp bracket. When installing the top cowling: 1. Set the top cowling straight down onto the engine, being careful to avoid catch- ing spark plug wires or other wires. 2. Align the three cowling hooks with the locks on the bottom cowling. 3.
Press down on the top of the cowling at the front and both sides of the back until the three locks click. ZMU03518 1 ZMU03979 1. Tilt support lever ECM00660 NOTICE Do not use the tilt support lever or knob when trailering the boat. The outboard motor could shake loose from the tilt sup- port and fall. If the motor cannot be trail- ered in the normal running position, use an additional support device to secure it in the tilt position. ZMU03519 4. To make sure the cowling is locked properly push the cowling from each side. If it lifts, repeat step 3. ECM00070 Make sure the cowling lock connection 24 NOTICE