Instruments and indicators EMU26493 Digital tachometer The tachometer shows the engine speed and has the following functions. All segments of the display will light momen- tarily after the main switch is turned on and will return to normal thereafter. ZMU01869 1 2 EMU26651 Hour meter This meter shows the number of hours the engine has been run. It can be set to show the total number of hours or the number of hours for the current trip. The display can also be turned on and off. 3 5 6 7 4 ZMU01891 1. Tachometer 2. Trim meter 3. Hour meter 4. Oil level indicator 5. Overheat-alert indicator 6. Set button 7. Mode button TIP:
The water separator and engine trouble-alert indicators only operate when the engine is equipped with the appropriate functions. ZMU01870 To change the display format, press the ” (mode) button. The display can show total hours or trip hours, or turn off. To reset the trip hours, simultaneously press the “ ” (set) and “ ” (mode) buttons for more than 1 second while the trip hours are displayed. This resets the trip counter to 0 (zero). The total number of hours the engine has been run cannot be reset. EMU26621 Trim meter This meter shows the trim angle of your out- board motor. Memorize the trim angles that work best for your boat under different conditions.
Adjust the trim angle to the desired using the power trim and tilt switch. If the trim angle of your motor exceeds the trim operating range, the top segment on the trim meter display will blink. EMU26551 Oil level indicator (digital type) This indicator shows the engine oil level. If the oil level falls below the lower limit, the 26