Instruments and indicators EMU26712 Fuel gauge Eight segments indicate the fuel level. When all segments are showing, the fuel tank is full. (set) and “ ” (mode) buttons at the same time. The trip distance is kept in memory by bat- tery power. The stored data will be lost if the battery is disconnected. ZMU01745 The fuel level reading can be inaccurate due to by the position of the sensor in the fuel tank and the attitude of the boat in the water. Operation with bow-up trim or continuous turning can give false readings. Do not adjust the selector switch for fuel sen- sor. Incorrectly setting the selector switch on the gauge will give false readings.
Consult your Yamaha dealer on how to correctly set the selector switch. NOTICE: Running out of fuel can damage the engine. [ECM01770] EMU26701 Clock To set the clock: 1. Be sure the gauge is in the “ ” (time) mode. 2. Press the “ ” (set) button; the hour dis- play will begin blinking. 3. Press the “ ” (mode) button until the desired hour is displayed. 4. Press the “ ” (set) button again, the minute display will begin blinking. 5. Press the “ ” (mode) button until the desired minute is displayed. 6. Press the “ ” (set) button again to start the clock. EMU36071 Trip meter / Clock / Voltmeter The display shows either the trip meter, the clock, or the voltmeter.
To change the display, press the “ (mode) button repeatedly until the indicator on the face of the gauge points to “ ” (trip meter), “ ” (clock), or “ ” (voltmeter). EMU26691 Trip meter This gauge displays the distance the boat has traveled since the gauge was last reset. The trip distance is shown in kilometers or miles depending upon the unit of measure- ment selected for the speedometer. To reset the trip meter to zero, press the “ The clock operates on battery power. Dis- 28