Trouble Recovery wheel or other moving parts when the engine is running. Do not install the starter mechanism or top cowling after the engine is running. Do not touch the ignition coil, spark plug wire, spark plug cap, or other elec- trical components when starting or op- erating the motor. You could get an electrical shock. EMU29562 Emergency starting engine 1. Remove the top cowling. 2. Remove the start-in-gear protection ca- ble from the starter, if equipped. 3. Remove the starter/flywheel cover after removing the bolt(s). ON START OFF ZMU01906 5. If equipped the choke knob, pull out it when the engine is cold.
After the engine starts, gradually return the choke knob to its home position as the engine warms up. ZMU03920 4. Prepare the engine for starting. For fur- ther information, see page 43. Be sure the engine is in neutral and that the clip is attached to the engine shut-off switch. The main switch must be “ ” (on), if equipped. ZMU03921 6. Insert the knotted end of the emergency starter rope into the notch in the flywheel rotor and wind the rope several turns around the flywheel clockwise. 7. Give a strong pull straight out to crank 74 ZMU02334