Safety - Section 2 OM2006.2 6/98 Page 2-20 Warnings and Cautions A plate attached to the right rear corner of the cab states the Rollover Protective Structure and Falling Object Protective Structure meets various SAE performance requirements. ! WARNING ! Do not make modifications to this structure, or attempt to repair damage without written approval from the Manufacturer. Unauthorized repairs will void certification. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DANGER plates are mounted on each suspension and accumulator cylinder. These plates warn that the sus- pensions and accumulators are charged with high pressure nitrogen.
No servicing of any kind should be attempted until the service manual has been refer- enced and proper and safe procedures are followed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Warning plates are attached to both the hydraulic tank and fuel tank to alert technicians not to work on the truck with the body in the raised position unless body-up retention device (pins or cable) is in position.