Komatsu — DISCUSSION OF ITEMS 1-21, FIGURE 3-9

OM3006.3 04/98 Operation - Section 3 Instrument Panel and Indicators Page 3-29 Auto Cruise Control (OPTIONAL) L.H. Control/Indicator Panel (Pod) This indicator (25, Figure 3-8) illuminates whenever the OPTIONAL Auto Cruise Control system (if installed) is activated. The Control/Indicator Panel (5, Figure 3-6), located to the left of the steering wheel, contains the following: ASR Monitor (OPTIONAL) This indicator (26, Figure 3-8) illuminates whenever the OPTIONAL traction control system (if installed) is activated. ABS Monitor (OPTIONAL) This indicator (27, Figure 3-8) illuminates whenever the OPTIONAL Anti-Slip Brake control system (if installed) is activated. FIGURE 3-9. L.H.

CONTROL/INDICATOR PANEL 1. L.H. Panel (Pod Assy.) 11. Service Brakes Applied 2. Engine Oil Temp. 12. Maintenance Monitor 3. Engine Coolant Level 13. Transmission Oil Filters 4. Low Steering Press. 14. Lamp Test Switch 5. Accumulator 15. Low Brake Pressure Pre-Charge Pressure 16. Lateral Slope Warning 6. Battery Charge (Amps)17. Crankcase Pressure 7. Check Engine 18. Panel Dimmer Switch 8. Parking Brake 19. Engine Oil Pressure 9. Body Float 20. Central Warning Lamp 10. Trans. Oil Temp. 21. A/C & Heater Vent Service Meter The Service Meter (28, Figure 3-8) dis- plays the total hours of operation for the truck.The meter advances whenever the engine is operating, even if the truck is not moving.

L.H. Panel/Pod Assembly The L.H. Panel/Pod Assy. (1, Figure 3-9) provides an array of indicator/monitor lights and three switches. NOTE: All the Indicator Lamps are RED in color; Except, # 11. which is AMBER/YELLOW . Odometer The Odometer (29, Figure 3-8) indicates the total dis- tance that the truck has traveled in miles or kilometers. Engine Oil Temperature The Engine Oil Temperature Monitor light (2, Figure 3-9) will illuminate if the engine oil temperature exceeds 250°F (121°C) for a continuous period of 5 seconds. If the lamp flashes and alarm buzzer sounds, stop the engine. At the same time, a fault code will be registered in the Centry System.

Refer to CENTRY FUEL SYSTEM DIAGNOSTICS later in this section.