Optional Equipment - Section 6 11/01 OM6005 Page 6-14 Payload Meter II OPERATOR FUNCTIONS Clearing the Operator Load Counter 1. Press the TOTAL/SFT switch once. The num- ber displayed is the total tons hauled since the last time the counter was cleared. The total is displayed in hundreds of tons. Using the Operator Load Counter Description The payload meter makes available to the operator a total load counter and haul cycle counter. This allows each operator to track the tons hauled during their shift. The total is displayed in hundreds of tons. For example, if 223 is displayed, this means that 22,300 tons have been hauled since the last time the cycle counter was cleared. 2.
Press and hold the CAL/CLR switch until the display flashes. 3. Press the CAL/CLR switch until "0000" is dis- played. After 2 seconds the meter will return to normal operation. Clearing this memory does not affect the main pay- load data storage. This memory location is separate from the main pay- load data storage. This memory is not cleared when the Data All Clear Operation is performed. Clearing this memory does not affect the main payload data storage. Dimming the Lights on the Display There are a total of 10 brightness levels on the PLM II display. Viewing the Operator Load Counter If there is a fault code present at this time: 1. Press the TOTAL/SFT switch once.
From the normal operation display: 1. Press the LIGHT/INC switch. The lighting will become one level dimmer. This will continue until the lighting has reached its lowest level. 2. The error code for that problem will be dis- played. This will be a flashing display. 2. After reaching the lowest level, the display will return to the brightest setting. 3. Press the TOTAL/SFT switch again. If addi- tional faults or warnings exist, that fault code will be displayed as a flashing code. 4. Repeat step #3 until no fault codes are dis- played. ":" will show when no additional faults exist. The display will then show total tons hauled since the last time the counter was cleared.
The total is displayed in hundreds of tons. If the switch is held in the depressed position, the brightness will change continuously. 5. Press the TOTAL/SFT switch again. The num- ber displayed is the number of haul cycles since the last time the cycle counter was cleared. 6. Press the TOTAL/SFT switch again. ":" is dis- played for 2 seconds before the display returns to normal operations.