Optional Equipment - Section 6 11/01 OM6005 Page 6-16 Checking the Operator Check Mode The Operator Check Mode is used to check and change several settings. These should be checked before the payload meter is put into service. 1. Press and hold the MODE switch. The display will show: 2. Press the MODE switch once. The display will show: Refer to "Data All Clear" to clear the haul cycle data. 3. Press the MODE switch once. The display will show: Refer to "Display of Fault Codes" for view- ing fault codes. 4. Press the MODE switch once. The display will show: This is the truck ID number. Refer to "Setting The Machine ID" to change Machine ID. 5.
Press the MODE switch once.The display will show. Refer to "Setting The Operator ID" to change operator. 6. Press the MODE switch once. The display will show: "SP:62" should be displayed. The The Speed Limit" to make adjustments. 7. Press the MODE switch once. The display will show: Refer to "Setting The Option Code" to change the option. 8. Press the MODE switch once.The current time should be displayed with the minutes flashing. Refer to and date. 9. Push the MODE switch to return to normal operation. Payload Meter II to ch ld be rvice. Checking the Service Check Mode eck and checked Refer to page 24 for additional information on UP Factor and PL Mode prior to setting these values.
o Setting "UP:XX" l . 1. Press and hold the LIGHT/INC and MODE switches. The display will show: o 2. Press and hold the LIGHT/INC and - . ine ID e " . e o avoi fer to ments . n e d o hange TOTAL/SFT switches. The display will show: 3. Press the CAL/CLR switch once. The display will show: 4. Press the LIGHT/INC switch until "XX" is set to . the desired gain (± 9%). 5. Press MODE. The display will show: 6. Press MODE and the meter will return to normal operation. Setting "PL:00" 1. Press and hold the LIGHT/INC and d unnec- MODE switches. The display will "Setting show: . 2. Press and hold the LIGHT/INC and TOTAL/SFT switches.The display will show: 3. Press the CAL/CLR switch once.
The display will show: 4. Press the CAL/CLR switch once. The display will show: 5. Press the LIGHT/INC switch until the time "PL:00" is displayed. ONLY "PL:00" IS RECOMMENDED. urn to normal 6. Press the MODE switch. The dis- play will show. 7. Press MODE and the meter will return to normal operation.