Optional Equipment - Section 6 Page 6-21 DOWNLOAD OF INFORMATIO Payload information and fault codes re be downloaded to a personal comput basis. The software required is availa number AK4635. Detailed instruction the software and downloading the d ™ with AK4635 PLM II download soft Data All Clear This function will erase all of the cycl ON/OFF data, and fault/warning data and the overall number of cycles will n IMPORTANT - Before clearing the d the data to a personal computer. To begin, the shift lever should be in th the brake lock set, the hoist control lev the "FLOAT" position and the body in tion. 1. Press and hold the MODE switch until "Cd:dP" is displayed. 2.
Press the MODE switch once. The display will show: 3. Press and hold the CAL/CLR switch until "A.CLE" is flashing. 4. Press the CAL/CLR switch agai and the memory will be cleared. then return to normal operation. This does not clear the Operator Load N DISPLAY OF FAULT CODES corded should 1. Press and hold the MODE switch er on a regular until "Cd:dP" is displayed. ble under part 2. Press the MODE switch once s for installing The display will show: ata is provided 3. Press the MODE switch once ware. The display will show: 4. Press the TOTAL/SFT switch. If there are no faults or warnings e data, engine the display will show for 6 sec . Total payload onds. ot be cleared.
If there are current faults or warni ata, download will be displayed in order of the highest priority first. Each code seconds. e "N" position, 5. After the current codes have be er should be in past history codes that have bee the down posi- displayed. Each code will flash fo . DE switch once show: AL/SFT switch. faults or warnings l show for 6 sec ent faults or warni ed in order of the first. Each code . , - ngs, the codes ir priority, the will flash for 6 nt codes have be des that have bee h code will flash fo en displayed, n reset will be r 3 seconds. If there are n after all history shown, the dis seconds:
The system wi o history codes o codes have bee play will show for ll then proceed to r n 3 the following displays: Refer n The meter will • Condition of th trucks or brake l Counter. to Page 25 for det e shift selector o ock on electric truc ails. n mechanical ks. The panel will display: "C1:XX" for 3 seconds, then indicate: Mechanical trucks "C1:oo" Shift selector is in "N". "C1:- -" Shift selector is not in "N'. Electric trucks "C1:oo" Brake lock is on. "C1:- -" Brake lock is off. • Condition of the Body Up Switch signal. The panel will display: "C2:XX" for 3 seconds, then indicate: "C2:oo" Body up switch is in up position. "C2:- -" Body up switch is in down position. display:
"C1:XX" for 3 seconds, cks lector is in "N". lector is not in "N'. ock is on. or 3 seconds, ock is off. Body Up Switch signal. display: "C2:XX" for 3 seconds, p switch is in up position. p switch is in down position.