OM4016 08/07 Maintenance - Section 4 Lubrication and Service Page 4-3 10 HOUR (DAILY) INSPECTION Prior to each operating shift, a “walk around” inspec- tion should be performed. Check the truck’s general condition. Look for evidence of leaks; check all lights and mirrors for clean and unbroken lenses; check operator's cab for clean and unbroken glass; check frame, sheet metal and body for cracks. Notify the proper maintenance authority if any discrepancies are found. Give particular attention to the following: Truck Serial Number ________________________ Site Unit Number ____________________________ Date:
__________ Hour Meter _________________ Name of Service Person ______________________ FLUID LEVELS & OTHER CHECKS - With Engine Stopped For the following checks, park the truck on a level surface, lower the dump body, and shut down the engine. a. Radiator - Check coolant level (2). Cool- ant level should be between FULL and LOW. If coolant is low, fill though cap (1) to FULL level with proper mixture as shown in Cooling System Recommendation Chart. CAUTION - If engine has been running, allow coolant to cool, before removing the fill cap or draining radiator. Serious burns may result if coolant is not allowed to cool. * - Check that there is no oil or other contaminants in the cooling system.
* - If the volume of added coolant is significant, check for possible leakage.Tighten cap securely. b. Batteries - Check electrolyte level and add distilled water if necessary. Inspect battery box cover for looseness or damage. c. Front Brake Oil Tank - Check oil level (2). Add oil if necessary. Remove cap (1). Use SAE 10W, Engine Oil ONLY. After adding oil, tighten cap securely. d. Drain moisture from tanks by pulling chains (1) on moisture drain valves. Check air tanks and lines for leaks. Check the brake cham- bers for leaks, damage, etc. COMMENTS CHECKED INITIALS