24. SERVICE PROCEDURE If the rear face of the hole for the pin of point is protruding to the front from the rear face of the pin hole for adapter , do not try to knock the pin in. There is something preventing point from entering adapter fully, so remove the obstruction. When point enters adapter fully, knock in lock pin . 8. Insert lock pin in the hole of the point and hit it until its top is the same level as the surface of point . 9. After replacing a bucket tooth, always check the following. 1) After the lock pin has been knocked in completely, check that it is being secured by the point and surface. 2) Lightly hit lock pin in the reverse direction from which it was hit in.
3) Lightly hit the tip of the point from above and below, and hit its sides from right and left. 4) Confirm that rubber pin lock and lock pin are set as shown in the figure. The life of the point can be lengthened and the frequency of its replace- ment can be reduced by turning it upside down so that it will wear evenly. Replace the rubber pin and locking pin with new pins at the same time as replacing the point to prevent the point from falling. PC130/150LGP-6K ENG 3-37