ATTACHMENTS AND OPTIONS SUPER LONG FRONT BOOM AND ARM MAINTENANCE 6 SPECIAL SERVICE REQUIREMENTS FOR SUPER LONG FRONT WORK EQUIPMENT 6 Before carrying out maintenance, always attach the WARNING TAG to the control lever in the operator’s cab. When working in water or in wet sand, use molybdenum lubricant (LM-P) for the grease. LUBRICATING 6 1. Set the work equipment in the greasing posture on next page, then lower the work equipment to the ground and stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out. 1. Boom cylinder foot pin (2 points) 6-47 WARNING CAUTION