3.3 Operation Operation 3. If it is difficult to thrust the bucket into the soil, operate the work equipment control lever to the left and right to move the cutting edge of the bucket up and down. GK020023 Digging and loading on level ground When digging and loading on level ground, set the bucket edge facing down slightly as follows and drive the machine forward. Always be careful not to load the bucket on one side and cause an unbalanced load. This operation should be carried out in 1st gear. Do not set the bucket facing down more than 20 degrees. 1. Set the edge of the bucket facing slightly down. GK032207 2.
Drive the machine forward and operate the work equipment control lever forward to cut a thin layer of the surface each time when excavating the soil. GK032208 3. Operate the work equipment control lever slightly up and down to reduce the resistance when driving the machine for- ward. When digging with the bucket, avoid imposing the digging force onto only one side of the bucket. GK032209 3-86 WA150-5H – VEAM934100 CAUTION CAUTION