3.4 Transportation Operation Loading 1. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 2. Apply the brakes on the trailer securely and insert blocks under the tires to ensure that the trailer does not move. Then fix the ramps in line with the centers of the trailer and the machine. Ramp Be sure that the two sides are at the same height as one another. Block Blocks Make the angle of the ramps a maximum of 15є. Distance between ramps Max. 15° Set the distance between the ramps to match the center of the tires. GK032225 If the ramp sags appreciably, reinforce it with blocks, etc. 3. Determine the direction of the ramp, then slowly load the machine.
4. Load the machine correctly in the specified position on the trailer. Securing machine Load the machine on to a trailer as follows. 1. Lower the work equipment slowly. Free 2. Check that the work equipment control lever is at the HOLD position, then set the safety lock lever to the LOCK position. 3. Turn the starting switch to the OFF position to stop the engine, and pull out the starting switch key. Lock 4. Lock front frame and rear frame with safety bar. GK032035 5. Put blocks in front and behind the wheels, and secure the machine with chains or wire rope to prevent the machine from moving during transportation.
In particular, attach the machine securely to prevent it from slipping sideways. 6. Always retract the car radio antenna fully (if equipped). GK032216 Lock Free 3-100 WA150-5H – VEAM934100