Foreword 1.7 CE-Conforming equipment 1.7.2 Manufacturer-supplied CE-Conforming equipment, according to document 416-93-H1120 The responsibility for observing valid regulations in the case of wheel loaders with "interchangeable equipment" (e.g. bucket or fork-lift) which was not supplied from works lies with the cus- tomer which was subsequently fitted to the machine. The directives for CE conformity and road-traffic registration are deemed to have been fulfilled when the manufacturer of the equipment confirms fulfilment of the form 416-93-H1120 along- side. The certification must be sent to the customer and the wheel loader manufacturer.
The CE conformity declaration for a spe- cific wheel loader is only legally valid once this has taken place. The dimensions X1, X2, Y1 and Y2 must be provided by the cus- tomer for approval for use on public roads. The dimension Sh (smallest tyre radius) must be added to the dimension D2. The figure G (in kg) represents the maximum load (equipment and operating load) which may act upon this point. D2 Sh Y2 X2 X1 Y1 G A1 A2 Sh GK032013 WA150-5H – VEAM934100 1-19