. OPERATION DETAILED CONTROLS AND GAUGES REMARK Swift Deceleration Switch WARNING 3 - 16 The engine does not start, if the safety lock lever is no t in the LOCK position. Make sure first t position, and then turn th Fuel Control Dial ntrol engine speed and output. e dial is turned to the left ounterclockwise) fully. he dial is turned to the right (clockwise) lly. This dial (2) is used to co ntrol engine speed and out (a) Low idling position: Th (c (b) High idling position: T fu REMARK When the swift decelerati on monitor is lighted up, the engine speed will remain at low idling even if the dial is operate d. To restore engine speed, press swi ft deceleration switch on the left work nction.
ork equipment control lever t o cancel the deceleration fu Always return the work equi pment and travel levers to the neutral position before operating the swift deceleration switch. If the switch is operated when any lever is being operated, the en gine torque will suddenly change. This switch (3) is used to activate the system to lowe r the engine speed and reduce the fuel consumption when the engine output is not requi red, such as when the trav el levers, travel pedals and work equip ment control levers are at t he neutral position.
When the swift decelerati on switch in the center of th e knob of the left work equipment contr ol lever is pressed, the swift deceleration monitor lights up and the engine speed goes down t o low idling. When the swift decele ration switch is pressed deceleration monitor goe speed set by the fuel con