Service Transmission Anti-Chatter Transmission Oil NOTE: Tractor is filled with John Deere Low Viscosity HY-GARD® (J20D) transmission oil at the factory. DO NOT mix oils. These tractors are equipped with a hydraulic wet disc PTO clutch. To avoid chatter, use only Low Viscosity HY-GARD® (J20D) transmission oil. DO NOT use type "F" automatic transmission fluid. John Deere Low Viscosity HY-GARD® (J20D) transmission oil is specially formulated to minimize clutch chatter, and to provide maximum protection against mechanical wear, corrosion, and foaming. Low Viscosity HY-GARD® may be used in all temperatures. Checking Transaxle Oil Level IMPORTANT: Avoid damage!
Check oil level when transaxle is cold. Check transaxle oil level before you operate vehicle. 1. Park vehicle on a level surface. 2. Slide seat forward. m71511 3. Remove dipstick (A). Wipe dipstick with a clean rag. 4. Install dipstick until it rests on top of fill tube. DO NOT tighten it. IMPORTANT: Avoid damage! DO NOT overfill. Too much oil can cause oil leaks. 87