OM3216 3/10 Operator Cab and Controls - Section 32 Page 32-35 CHECKING FAILURE CODES If an action code is present on the character display, check the failure codes as follows: 1. Press (>) on mode select switch 2 to display the failure code. The failure code for that action code will be displayed on the character display. 2. Press (>) on mode select switch 2 again to see if any other codes are present. Check the failure code for each action code present and note. If no other codes are present, the character dis- play will return to the service meter/odometer. The six digit code displayed on the top line of the character display is the failure code.
The code dis- played to the right of the failure code is the controller that detected the fault. MON: Machine Monitor TM: Automatic Transmission Controller BK: Retard Control Module The bottom line on the character display lists the sys- tem where the failure was generated.