General Safety - Section 20 10/04 OM2034 Page 20-12 DURING MAINTENANCE Personnel Only authorized personnel can service and repair the machine. Extra precaution should be used when grinding, welding, and using a sledge-hammer. Attachments Place attachments that have been removed from the machine in a safe place so that they do not fall. If they fall on you or others, serious injury could result. Work Under The Machine Always lower all movable work equipment to the ground or to their lowest position before performing service or repairs under the machine. Always block the tires of the machine securely. Never work under the machine if the machine is poorly supported.
Keep The Machine Clean Spilled oil or grease, or scattered tools or broken pieces are dangerous because they may cause you to slip or trip. Always keep your machine clean and tidy. If water gets into the electrical system, there is danger that the machine may not move or may move unexpectedly. Do not use water or steam to clean the sensors, connectors, or the inside of the operator's compartment. Be extremely careful washing the electrical control cabinet. Do not allow any water to enter the control cabinet around the doors or vents. Do not allow any water to enter the cooling air inlet duct above the electrical control cabinet.
If water enters the control cabinet (through a vent or the cooling air system) major damage to the electrical components is possible. Never spray water into the rear wheel electric motor covers. Damage to the wheel motor armature can occur. Do not spray water into the retard grids. Excess water in the retard grids can cause a ground fault, which will prevent propulsion. Rules To Follow When Adding Fuel Or Oil Spilled fuel and oil may cause slipping. Always clean up spills immediately. Always tighten the cap of the fuel and oil fillers securely. Never use fuel for washing any parts. Always add fuel and oil in a well-ventilated place.