OPERATION 13.2 PRECAUTIONS FOR LOADING After loading the machine, secure it in place as follows. 1. Lower the work equipment slowly. 2. Apply the safety lock to lock all the control levers. 3. Turn the starting switch to the OFF position and stop the engine. Remove the key from the starting switch. 4. Lock front frame and rear frame with safety bar. 5. Block the wheels, and secure the machine with chains or rope to hold it stationary during transportation. 6. Fully retract the cab radio antenna. 13.3 PRECAUTIONS FOR TRANSPORTATION WARNING Consider the width, height and weight of the machine when choosing a route for transporting it.
Obey all the state and local laws governing the weight, width and length of the load. Observe all regulations governing wide loads and traffic. 13.4 LIFTING MACHINE WARNING Wire rope used to lift the machine must be fitted correctly or the machine may fall and cause death or serious injury to personnel and/or damage to equipment. Stop after a short lift (100-20 mm (3.9 - 7-9 in.)) and check that the machine is horizontal with no slack in the wire rope, then continue to lift the machine. Before lifting the machine, stop the engine and lock the brakes. WARNING Lifting operations using a crane must be carried out by a qualified operator. Never raise the machine with a worker on it.
Make sure the equipment used for lifting is adequate in capacity and design for the load. Use only the procedures and positions given in this publication to lift the machine. 2-73 WA320-3MC