OPERATION 16.3 IF BATTERY IS DISCHARGED WARNING When checking or handling the battery, stop the engine and turn the starting switch key to the OFF position before starting. Before starting the engine, use a damp cloth to wipe dust and debris from the top surface of the battery. The battery generates hydrogen gas, so there is danger of explosion. Keep flames, sparks and lighted cigarettes away from the battery. Battery electrolyte is dilute sulfuric acid, and it will damage clothes and skin. If it gets on your clothes or on your skin, wash it immediately off with lots of water. If it gets in your eyes, wash it out with fresh water, and consult a doctor.
When handling battery, always wear protective goggles. When removing the battery, first disconnect the cable from the ground terminal (normally, the negative (-) terminal). When installing, install the positive (+) terminal first. If a tool touches the cable connecting the positive terminal and the chassis, there is danger that it will cause sparks. If the terminals are loose, the defective contact may generate sparks that will cause an explosion. Make sure the terminals are installed tightly. When removing or installing, check which is the positive (+) terminal and negative (-) terminal.
16.3.1 REMOVAL AND INSTALLATION OF BATTERY When removing the battery, first disconnect the cable from the ground terminal (normally, from the negative (-) terminal). If a tool touches a cable and connects positive terminal and the chassis, there is danger of sparks. When installing battery, the ground cable should be connected to the ground terminal as the last step. REMARKS: The batteries are on both sides of the rear of the machine. The battery used for the ground is on the left side on the machine. 2-84 WA320-3MC