MAINTENANCE 5. When the engine timing pin engages the hole in the camshaft gear, Cylinder Number 1 is at TDC on the compression stroke. WARNING Be sure to disengage the engine timing pin after locating TDC to prevent damage to the engine timing pin. 6. Intake Clearance: . . . . . . . . . . . . . . . . . . 0.30 mm (0.012 in) Exhaust Clearance: . . . . . . . . . . . . . . . . . 0.61 mm (0.024 in) Check or set valves with engine cold - below 60 REMARK The clearance is correct when some resistance is felt as the feeler gauge slips between the valve stem and the rocker lever. Step A Locate top dead center (TDC) for cylinder number 1. Check/Adjust the valves . . . . . . . . . . . . . .
.I = Intake; E = Exhaust Locknut . . . . . . . . . . . . . . . . . . . . . . . 24 N After tightening the rocker lever locknut, check the valve clearance to make sure it has not changed. 3-61 WA320-3MC