OPTIONS, ATTACHMENTS E. Repeat the procedure for each button and four bands. You can change any pre-set without affecting the others. It’s unlikely that more than one Weather Band station will be available in a given area, so most of the Weather Band pre- sets will go unused. 11. DOLBY ® NOISE REDUCTION ( ) Dolby noise reduction helps reduce background noises com- mon on cassette recordings. If cassette has been recorded with Dolby noise reduction (indicated by the Dolby symbol), press this button to engage the system. Press the button again to turn the system off. To most listeners, tapes recorded without Dolby noise reduction sound better when played back without Dolby noise reduction.
Dolby and are trademarks of Dolby Laboratories Licensing Corporation. 12. AUTO-METAL TAPE SENSOR Cassettes with metal or CrO2 tape require special equalization circuitry to play back the best sound. The system automatically recognizes and adjusts for the special tape and displays “MTL on the LCD display. 30.2.3 SETTING THE CLOCK 1. Turn on the radio power. Remove cassette from the player. 2. Press and hold R/T button (9) until the time display begins to flash. Release the R/T button. 3. Within 10 seconds of releasing the R/T button, press the down tuning (DN) (8) to advance hours. Press the UP button (7) to advance minutes. 4.
About 10 seconds after the time is set, the display will stop flashing and time keeping will begin. 30.2.4 REMOTE CONTROL UNIT 1. Turn off radio power. 2. Grasp the sides of the remote at the top serrated edges and pull upward. NOTE: The remote when removed from the cradle is inoperable and power has been turned off. Do not expose the remote or cradle to extreme heat, direct sunlight, solvents or water. Use slightly damp, soft cloth to lean the remote; never immerse in water. Keep the male telephone-type plug in the cradle clean. Use of a damp cotton swab is acceptable. 3. Reverse steps 1 and 2 to reinstall the remote control unit. WA320-3MC 5-14