Checking the Operator Check Mode Checking the Service Check Mode The Operator Check Mode is used to check and change several settings. These should be checked before the payload meter is put into service. 1. Press and hold the MODE switch. The display will show: Refer to UP Factor and PL Mode for additional information prior to setting these values. 2. Press the MODE switch once. The display will show: Refer to "Data All Clear" to clear the haul cycle data. Setting "UP:XX" 1. Press and hold the LIGHT/INC and MODE switches. The display will show: 3. Press the MODE switch once. The display will show: Refer to "Display of Fault Codes" for viewing fault codes. 2.
Press and hold the LIGHT/INC and TOTAL/SFT switches. The display will show: 4. Press the MODE switch once. The display will show: This is the truck ID number. Refer to "Setting The Machine ID" to change Machine ID. 3. Press the CAL/CLR switch once. The display will show: 4. Press the LIGHT/INC switch until "XX" is set to the desired gain ( ± 9% ). 5. Press the MODE switch once.The display will show. 5. Press MODE. The display will show: Refer to "Setting The Operator ID" to change operator. 6. Press MODE and the meter will return to normal operation. 6. Press the MODE switch once. The display will show."SP:62" should be displayed.
The speed limit should be set to 62 to avoid unnecessary faults and warnings. Refer to "Setting The Speed Limit" to make adjustments. Setting "PL:00" 1. Press and hold the LIGHT/INC and MODE switches. The display will show: 7. Press the MODE switch once. The display will show: 2. Press and hold the LIGHT/INC and TOTAL/SFT switches. The display will show: Refer to "Setting The Option Code" to change the option. 8. Press the MODE switch once. The current time should be dis- played with the minutes flashing. Refer to "Setting The Time And Date" to change the time and date. 3. Press the CAL/CLR switch once. The display will show: 4. Press the CAL/CLR switch once. The display will show: 5.
Press the LIGHT/INC switch until "PL:00" is displayed. ONLY "PL:00" IS RECOMMENDED. 9. Push the MODE switch to return to normal opera- tion. 6. Press the MODE switch. The display will show. 7. Press MODE and the meter will return to normal operation. M20-16 Payload Meter II M20007.1 03/02