28. USING SEAT BELT 28.1 SEAT BELT ¤ WARNING Before fastening the seat belt, inspect the securing brackets and belt for abnormal conditions. Replace any worn or damaged seat belt or the securing brackets. Adjust and fasten the seat belt before operating the machine. Always use seat belt when operating the machine. Do not use seat belt with either half of the belt kinked. 28.1.1 FASTEN THE BELT AND REMOVE IT 1. Adjust the seat so that the operator still feels that there is sufficient knee room when fully depressing the pedal while seated, with operator's back against the backrest. 2. For suspension-type seat, adjust tether belt 1 , after adjusting the seat position. 3.
After adjusting the seat position, sit in the seat. Grip buckle 2 and tongue 3 in each hand and insert tongue 3 into buckle 2 . Confirm by pulling the belt that the tongue is securely locked to the buckle. 4. When removing the belt, raise the tip of buckle 2 lever to release it. Fasten belt along your body without kinking it. Adjust the lengths of the belt on both the buckle and the tongue sides so that the buckle is located at the mid-point of your body front. AM092660 5-5