Maintenance Section Bulbs Check Inflation and Damage Bulbs are identified as follows [Diesel Engine] Inspect tires for wear, cuts, gouges and foreign objects. Look for bent rims and correct seating of locking ring. Check tires for proper inflation. See "Tire Inflation Pressures". To inflate tires always use a clip-on chuck with a minimum 60 cm (24 inches) length of hose to an inline valve and gauge. Always stand behind the tread of the tire. NOT in front of the rim. 1. Bulb-head lamp halogen(24V-70/75W) 2. Bulb-rear(24V-55W) 3. Bulb-turn signal(Front, 24V-25/10W) 4. Bulb-turn signal(Rear, 24V-25W) 5. Bulb-stop & tail(24V-25/10W) 6. Bulb-back up(24V-10W) [LP Engine] 1.
Bulb-head lamp halogen(12V-60/55W) 2. Bulb-rear(12V-55W) 3. Bulb-turn signal(Front, 12V-23/8W) 4. Bulb-turn signal(Rear, 12V-23W) 5. Bulb-stop & tail(12V, 23/8W) 6. Bulb-back up(12V-10W) Tires and Wheels - Inspect, Check Servicing and changing tires and rims can be dangerous and should be done only by trained personnel using proper tools and procedures. Deflate tire before removing wheel nuts from the truck. Typical Example Do not reinflate a tire that has been run while flat or underinflated, without first checking to make sure the rim is not damaged and is in the correct position.
When tires are changed, be sure to clean all rim parts and, if necessary, repaint to stop detrimental effects of corrosion. Sand blasting is recommended for removal of rust. Check all components carefully and replace any cracked, badly worn, damaged and severely rusted or corroded parts with new parts of the same size and type. If there is any doubt, replace with new parts. Do not, under any circumstances, attempt to rework, weld, heat or braze any rim components. If correct procedures are not followed while servicing tires and rims, the assemblies could burst with explosive force and cause serious physical injury or death.
Follow carefully the specific information provided by your tire servicing man or dealer. 144 WARNING