Maintenance Section 5. Put a small amount of clean oil on the seal gasket on the new filter. Install the filter by hand. When the filter contacts the base, tighten it an additional 3/4 turn. 6. Close the hood and seat assembly. 7. Open the access door in the floor plate. Typical Example D50/60/70S-5 (2 Speed), G50/60/70S-5 2. Wash the strainer (screen) , spring and drain plug in clean, nonflammable solvent. Dry the strainer, spring and drain plug. [D50/60/ 70S-5 (2 Speed), G50/60/70S-5 Only] 3. Install the drain plug. Typical Example D50/60/70/80/90S-5 (3 Speed) Typical Example D50/60/70/80/90S-5 (3 Speed) Typical Example D50/60/70S-5 (2 Speed), G50/60/70S-5 8.
Remove the dip stick/filter cap. Fill the compartment with oil. See "Refill Capacities". Install the dip stick/filter cap. 9. Start the engine. 10. With the service brake applied and engine at low idle, shift the transmission to forward and reverse to fill the clutches. 11. Shift the transmission into NEUTRAL. Engage the parking brake. 12. Loosen the oil dipstick counter-clockwise, remove and clear it. Insert the oil dipstick slowly into the oil level tube until contact is obtained, and pull the dipstick out again. Typical Example D50/60/70S-5 (2 Speed), G50/60/70S-5 4. Rotate the oil filter counter clockwise to remove it.
• Replacement Interval of Transmission Oil Filter D50/60/70S-5 (3 Speed) : Every 1,000 Service Hours or 6 Months. D50/60/70S-5 (2 Speed), G50/60/70S-5 : Every 500 Service Hours or 3 Months. 154