Maintenance Section Diesel Engine Truck (Dual Element) 10. Start the engine and observe the position of the indicator. If the indicator shows RED after the installation of the primary element, install another clean or a new element or, replace the secondary element. See topic, "Air Intake System - Change" in Every 1000 Service Hours or 6 months section. 11. Stop the engine and close the right side cover. 1 Typical Example LP Engine Truck 2 Typical Example 2. Replace the nut or clamp(1). 3. Remove the element to separate it from its base and remove it from the air cleaner housing. 4. Clean and inspect the element (2). 5. Clean the inside of air cleaner housing and the cover.
Inspect all connections between the air cleaner and carburetor. Check intake hose for cracks, damage and loose clamps. Tighten or replace parts as necessary to prevent leakage. Do not allow dirty air to enter the intake hose when cleaning the inside of the cleaner housing . NOTICE 6. Check the air cleaner housing for loose latches. 7. Reset the air cleaner service indicator. 8. Install the air filter element. 9. Install the cover and tighten the cover latches. 161