Doosan D90S-5 — Doosan D90S-5 User Manual

Maintenance Section Hydraulic Oil Level – Check Drive Axle Oil Level – Check At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Hot oil can cause burns. Remove the filter cap only when the engine is stopped, and the cap is cool enough to touch with your bare hand. Remove the filter cap slowly to relieve pressure. Shoe Brake Type Park the lift truck on a level surface, parking brake applied, transmission in neutral. 1. Raise the carriage high enough to access the drive axle hosing level/fill plug. 2.

Block the bottom of the carriage with a block of wood to hold the carriage in the raised position. 3. Turn the ignition switch OFF. 1. Operate the lift truck for a few minutes to warm the oil. Park the lift truck on a level surface, with the forks lowered, mast tilted back, parking brake engaged, transmission in NEUTRAL and the engine stopped. 2. Raise the hood and seat assembly. Make sure the air lift cylinder securely holds the hood open. Typical Example 4. Remove the drive axle housing level/fill plug. 5. Check if oil reaches the bottom of level/fill hole. 6. Maintain oil level to the bottom of level/fill hole. 7. Install the drive axle housing level/fill plug. 8.

Remove the wood blocking and lower the carriage. 9. Align planetary hub level/drain/fill plugs to the horizontal position. 10. Remove the plugs and check if oil reaches the level/drain/fill hole. 11. Maintain the oil level to the hole. 12. Install the planetary hub level/drain/fill plugs. 3. Check the oil level. 4. Maintain the oil level to the FULL mark on the dip stick/filter cap assembly. 5. Install the dip stick/filter cap assembly. 164 WARNING WARNING