Doosan D90S-5 — Doosan D90S-5 User Manual

Maintenance Section Every 1500 Service Hours or 9 Months You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Drive Axle Oil (Shoe Brake Only) - Change See topic, "Drive Axle Oil - Change" in "First 50-100 Service Hours or a Week. Inspect Ignition System (LP Engine Only) 1. Disconnect Battery Cables. 2. Remove and inspect the spark plugs. Replace as required. 3. Test secondary cables with an Ohmmeter. If maximum resistance is higher than 25 kOhms, repair and/or replace. 4. Remove distributor cap and perform visual inspection.

Replace cap and rotor if corrosion is found on the contacts. 5. Inspect the ignition coil for cracks and heat deterioration. Visually inspect the coil heat sink fins. If any fins are broken replace as required. Replace Spark Plugs (LP Engine Only) 1. Disconnect Battery Cables. 2. Using a gentle twisting motion remove the high voltage cables from the spark plugs. Replace any damaged cables. 3. Remove the spark plugs. 4. Gap the new spark plugs to the proper specifications. G643(E) Engine : 0.9mm (0.035 inch) 5. Apply anti-seize compound to the spark plug threads and install. G643(E) Engine : 30 N•m (22 lb•ft) DO NOT OVERTIGHTEN THE SPARK PLUGS. 6. Re-install the high voltage cables.

178 CAUTION