Doosan D90S-5 — Doosan D90S-5 User Manual

Maintenance Section Every 2000 Service Hours or Yearly You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Steer Wheel Bearings - Reassemble Park the lift truck level with the forks lowered, parking brake engaged, transmission in NEUTRAL and the engine stopped. Typical Example 4. Remove the wheel assembly. Examine the wheel for damage and wear. Replace the wheel if necessary. 5. Remove the inner bearing. Clean and lubricate the steering knuckle. Reassemble both the inner and outer bearing cones. 6. Install the inner bearing.

Lubricate the seal and install the wheel assembly on the knuckle. 7. Install the outer wheel bearing and the outer nut. 8. Tighten the nut to 200 N•m (148 lb ft), while turning wheel hub to seat the bearing. 9. Install the pin. 10. Install the hub cap. 11. Raise the lift truck and remove the blocking Lower the lift truck to the ground. Typical Example 1. Lift the steer wheels off the ground. Place stands or blocking under the frame and steer axle to support the lift truck. 2. Remove the hub cap and gasket. Typical Example 3. Remove the pin (1) and nut (2). Remove the outer wheel bearing. 181