www.changlin.com.cn 75 mm T-Bar Puller Pull the fuel injection pump drive gear loose from the shaft. 10 mm, 15 mm Remove the four mounting nuts and the capscrews that fasten the fuel injection pump support to the cylinder block. Remove the rear support bracket for the PES6P fuel injection pump. Remove the fuel injection pump. NOTE: The industrial governor is shown in the illustration. The procedure is the same for automotive governors. 111 / 149 pages Installing Part No. 3377371 Engine Barring Gear Make sure the engine has cylinder number 1 at TDC.
Fuel Injection Pump-Timing The fuel injection pump also has a timing pin (1), located in the governor housing, to position the fuel injection pump shaft to correspond with TDC for cylinder number 1. After the fuel injection pump is installed, the timing pin is to be reversed and stored in the housing (2).