www.changlin.com.cn Caution: If a replacement or repaired pump was installed, be sure to fill the governor housing with clean 15 W 40 engine lubricating oil before starting the engine. Failure to do so will result in damage to the fuel pump camshaft and governor fly weights. Fuel Injection Pump-Venting 10 mm, 17 mm The PES. MW pump must be vented after installation. Loosen the vent screw located near the front on the side nearest to the engine. Crank the engine so air can bleed from the fuel injection pump, then tighten the vent screw. NOTE: Earlier PES. MW fuel injection pumps were not equipped with a vent screw.
Remove the large plug from the location described above to vent the fuel injection pump. PES. A pumps are self venting. Torque Value: 9N .m [80 in-lb] Vent each high pressure fuel line separately until the engine runs smoothly. Tighten the high pressure fuel lines. Torque Value: 17 mm 24N•m [18 ft-lb] 19 mm 30N •.m [22 ft-lb] Injection Pump‐Idle Speed Adjustment RSV Governor Idle adjustment for industrial engines requires the setting of both the low idle screw (1) and the bumper spring screw (2). Caution: Failure to set low idle with bumper spring could result in an unstable governor(engine surge). 116 / 149 pages Governor Housing Oil Capacity ml fl.o z. 50 RS V 15. 2 50 RQV, RQ VK 25.
4 00 RSV-H 16. 9