OM6004 Optional Equipment - Section 6 Haulpak Payload Meter Page 6-5 To replace paper: 1. Press the "FEED" button to roll out the remaining paper. Do not forcibly pull the paper out. 2. Pull the cover open from the top. 3. Unroll about 3 inches from a new roll. 4. Hold the new roll in front of the printer paper input with the 3 inch leader coming from the top of the roll. 5. Insert the leader into the printer paper input and press the "FEED" button. Hold the button until about 6 inches has fed through the printer. 6. Pass the paper through the cover and close. CLEAR MEMORY NOTE: Print out all data stored in memory before clearing memory. 1. Push the "CLEAR" button for 1 second.
Display will blink "CLEA". 2. Push the "CLEAR" button again. Display will show "CLEA" for 3 seconds then return to normal display logic. NOTE: To cancel clear operation when display is blinking "CLEA", push "CAL". CALIBRATION The calibration function measures and stores in memory the empty truck sprung weight. This data is subtracted from live load data to calculate payload weight. During calibration suspension pressure sensors and inclinometer outputs are acquired and averaged over a 30 seconds interval while the empty truck is driven at a steady 6 MPH on a level smooth haul road. This data is not lost when power is removed from the payload meter. Carry out the calibration procedure:
After delivery of the machine After adjusting suspension oil/gas charge After modifying the machine After adjusting tire pressure After replacing a sensor After a sensor check indicates the no load weight has changed.