OM6004 Optional Equipment - Section 6 Haulpak Payload Meter Page 6-7 SETTING THE TIME OF DAY 1. Press the "ADJ" button and hold until the digits begin blinking. 2. Press the "INC" button to change the blinking digits. The time is displayed as a 24 hour clock. 3. Press the "SFT" button to blink the hours digits, then month, day and year digits. 4. Press the "ADJ" button to end the time setting function. The clock accuracy is ± 3 minutes per month. ERROR CODES The payload meter continually monitors the status of the sensor inputs and relay driver outputs. If an abnormality is found, an error code is displayed.
Once an error code has appeared, it may be canceled by pressing the "CAL" button or cycling the power. ERROR CODE ERROR CODE TABLE DESCRIPTION DETECT TIME DELAY E-31 E-32 E-33 18 Volt sensor power short circuit to ground. Relay short circuit. Backup battery voltage less than 2.6 volts. 5.0 sec. 0.1 sec. 5.0 sec. E-01 E-02 E-03 E-04 Right rear sensor disconnected – circuit 39FA. Left rear sensor disconnected – circuit 39FB. Right front sensor disconnected – circuit 39FC. Left front sensor disconnected – circuit 39FD. 5.0 sec. E-11 E-12 E-13 E-14 Right rear sensor short circuit. Left rear sensor short circuit. Right front sensor short circuit. Left front sensor short circuit. 5.0 min.
E-41 E-42 Inclinometer output > = + 10 degrees. Inclinometer output 5.0 min. PAPE Paper jammed. 10 sec. FULL Memory full (200 haul cycles). E-21 E-22 E-23 E-24 Right rear sensor check error. Left rear sensor check error. Right front sensor check error. Left front sensor check error. Once an error code has appeared, it may be cancelled by pushing the "CAL" button or cycling the power.